============================================
SquirrelView V3.9B(B01)      Jan 2020 DMN R60
============================================

Please read the release note on the disk 
before installing and take particular note 
of the points in this document.


CONTENT
=======
- INSTALLATION NOTES
- ARCHIVE, TEMPLATES AND TOLERANCE CURVES
- NOTES ON OPERATING SYSTEMS
- 32-BIT / 64-BIT USB DRIVER FOR THE OQ610
- SECURTY SETTINGS
- REGIONAL SETTINGS
- LEGACY LOGGERS
- ELTEK 1000 SERIES LOGGERS


INSTALLATION NOTES
==================
Due to major changes being made for 
international compatibility, a seamless 
upgrade is not available from versions 1.03 
or older.  

The SquirrelView system folder will be 
deleted removing all runs and data 
previously imported into Analysis. However, 
the original data files will remain (in the 
dat files directory) and can be re-imported 
with this new version.

Note that Version 3.x will run in parallel 
to any previous versions if required. To do 
so, install into a different location when 
prompted, therefore leaving all previously 
imported runs and data intact.


ARCHIVE, TEMPLATES AND TOLERANCE CURVES
=======================================
Analysis archive, template and tolerance 
curve files from 1.03 or older are not 
compatible with this version of SquirrelView 
due to the reasons above.


NOTES ON OPERATING SYSTEMS
==========================
SquirrelView is only supported when used 
with:

    
    Windows 7 and above (32-bit and 64-bit)
   

32-BIT / 64-BIT USB DRIVER FOR THE OQ610
========================================
SquirrelView 3.7 and above ships with a USB driver 
for the OQ610 logger supporting both 32-bit 
and 64-bit architectures.

To use SquirrelView 3.7 or above with an OQ610 logger 
the new driver must be used. If this is an 
upgrade to an existing installation, the 
driver must be updated manually after 
installing SquirrelView 3.7 or above.

The driver may be updated as follows,
depending upon operating system:

On 32-bit Windows 7:
 open the Device Manager from the System 
  control panel
 connect the logger
 the logger will appear as "Grant 610 Data 
  Logger" under the "DriverX USB" heading

 choose Update Driver Software... from its 
  context menu to start the update process
 choose "Search automatically for updated 
  driver software" when asked how to search
 the new driver installs

On 64-bit Windows 7:
 connect the logger
 the new driver installs automatically

On 32-bit Windows 8 and above:
 the new driver installs automatically

On 64-bit Windows 8 and above:
 the new driver installs automatically

The logger is now ready to use.


SECURITY SETTINGS
=================
It is important that at least one user is 
created before the security level is changed
from None.


REGIONAL SETTINGS
=================
Unsupported Regional Settings:

   Bulgarian, Latvian, Hungarian


LEGACY LOGGERS
==============
1. 8-Bit Loggers are NOT supported in 
   SquirrelView version 3.x

2. 1200 and 1250 loggers have limited 
   support within SquirrelView and must be 
   enabled by use of the Tools->Preferences 
   option. (Plus edition is required)

If any of these loggers are being used, you 
should consider upgrading them to a new 
model. Please contact Grant Instruments 
sales for upgrade opportunities.


ELTEK 1000 SERIES LOGGERS
=========================
ELTEK Loggers are not currently supported 
within SquirrelView.

